Search the Community
Showing results for tags 'RGH 1.2'.
Found 3 results
I was recently playing my rgh xbox360 slim, it was connected with an ethernet cable to the LAN. When I clicked aurora home, it rebooted and went into the normal (outdated retail) dash and said something about updating the xbox has failed. Eject button isn't working at all therefore can't boot into xell. When I boot normally it sometimes goes to the dash and sometimes red ring with some error number, a few times it even booted into aurora and then immediately rebooted. The device doesn't seem to recognize the hard drive, I tried putting my hard drive in another xbox an it did recignize it. I have no backup of the nand dump. Is it possible to fix this? Thanks in advance.
I have searched the internet to no avail. I hope somebody can help me here. I have done my fare share of RGH 1.2, and RGH 2, but never had this issue. My Coolrunner keeps glitching at the same rate no matter what timing file I put in it. I can't get xell to boot. I tried pulling the wires one at a time, if I remove RST, PLL, or POST it quits trying to glitch. The CLK doesn't seem to make a difference. If I re-write my original nand, it boots fine so hardware is still good. I forgot to mention, I'm doing RGH 1.2 on a Jasper 256mb. If anyone could help me it would be greatly appreciated.