X0_LOJ_0X 0 Posted June 3, 2018 So i got a slim E series (corona v6) with a ace v3 installed. Problem is it takes forever to boot sometimes, its very incosistent, sometimes its insta boots, sometimes boots within 3-5 cycles but most of the times it takes between 10-15 cycles before it boots. So i did some research and found that i could tune it with some capacitors for a better and more consistent boot ( i already trimmed the wires but that didnt improve boot times) So the caps i bought are ceramic 10uf 50v. Is it ok to use a cap with such a high voltage, if not what rating caps would u guys recommend. Also my 360 has the winbond 2kb ram, heard 360 with them are problematic to glitch, could this contribute to the inconsistent boots? Link to caps i bought: https://m.ebay.com/itm/20Pcs-Lot-50V-475-335-106-225-Monolithic-Ceramic-Chip-Capacitor-5-08mm/192156148520?_mwBanner=1&ul_ref=https%3A%2F%2Frover.ebay.com%2Frover%2F0%2F0%2F0%3Fmpre%3Dhttps%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F192156148520%26rvr_id%3D0%26rvr_ts%3Dc7adcac11630aad325468656fff9c2fc&ul_noapp=true Quote Share this post Link to post Share on other sites
gavin_darkglider 1562 Posted June 4, 2018 Have you looked into S-RGH timing files? I have had better luck with that. Project Muffin is worth looking into also, which is basically cr4 wiring with a cheap chip. Quote Share this post Link to post Share on other sites