Jump to content
RealModScene
devilhunter

Looking for Xbox 360 (Dashboard 7371 or Less)

Recommended Posts

I would also suggest removing the resistor on the top side CPU_RST point, and bridging the points. Then use the point on the header by the CPU for CPU_RST. Also, try putting the coolrunner on the cpu heatsync, so you can keep the wires as short as possible.

  • Like 1

Share this post


Link to post
Share on other sites
4 hours ago, gavin_darkglider said:

I would also suggest removing the resistor on the top side CPU_RST point, and bridging the points. Then use the point on the header by the CPU for CPU_RST. Also, try putting the coolrunner on the cpu heatsync, so you can keep the wires as short as possible.

Tried that already.

Share this post


Link to post
Share on other sites

What is your point, that I replied on another forum?, Yes, it was me, and I stand by what I said, if you sent it to me, I could probably get it to glitch in a timely  manor. 

Share this post


Link to post
Share on other sites
On 1/21/2017 at 8:35 PM, devilhunter said:

, it should be noted that some consoles (Jasper) are unglitchable. It's pretty rare to get across one ( actually glitches once after 2 mins !!!) 

You had a terrible timing profile if you couldn't do it with a chip. Jaspers usually glitch for me within15-20 seconds from boot. Thing is, You have to dick with them forever to get to glitch the first time, then afterwards use rater and get the proper settings.

 

Share this post


Link to post
Share on other sites

i have one. its a falcon Korean region. with a flashed DVD Drive. all what i recommend is to open it and replace the cheap thermal paste with a good one

Capture_4.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...