BlueSn00w 21 Posted May 10, 2017 -snip- seriously, read the date Quote Share this post Link to post Share on other sites
Anto 1 Posted May 10, 2017 That is some horrible soldering. You need to shorten the ends of the wire. Some of those wires look like they may be touching the adjacent via points. 1 Quote Share this post Link to post Share on other sites
felida 1653 Posted May 10, 2017 Yeah the soldering is completely horrible.. plus.. that green wire looks like a cold joint.. clean it up, trim the wires down til like 4-5 cm is only showing.. and for the love of god.. use actual electronic flux, not plumbing flux like most people use Quote Share this post Link to post Share on other sites
Blackjack 43 Posted May 10, 2017 Your J2C3 points 7 and 8 are short circuited. The ones next to the green and blue wires. And what happened to your usb cable ? A mouse nibbled it ? The pictures are of good quality the soldering not. 1 Quote Share this post Link to post Share on other sites
BlueSn00w 21 Posted May 10, 2017 -snip- seriously, read the date Quote Share this post Link to post Share on other sites
felida 1653 Posted May 10, 2017 6 minutes ago, BlueSn00w said: Ok resolderd same error I think my nandx might be broken Tbh they all look like cold joints to me.. like wire is just placed.. have you tried to verifiy connections with a multimeter set to ohms?? Quote Share this post Link to post Share on other sites
Anto 1 Posted May 11, 2017 That is barely an improvement. If I were you, I would send it to a pro. Quote Share this post Link to post Share on other sites
Swizzy 2084 Posted May 11, 2017 There's also a chance that there's a solder ball underneath the motherboard which connects points together, which is something we can't see in your picture(s) it's very rare that a NAND-X breaks, even with shitty soldering... Quote Share this post Link to post Share on other sites