gavin_darkglider 1562 Posted June 6, 2015 So, I just picked up a rgh 1 possible console, and the only coolrunner I have left in stock is one that I pulled from an rgh2 console when r-jtag came out. Unfortunatly, it is missing a pad on the JP Jumper(The one closest to the caps.) Any help in tracing where this goes, would be appreciated, so I can get this console finished and sold. Also, this console for a jasper, has a benq drive, and needs a new laser, I have a liteon phat drive, can I pull the laser from that, and use it in the benq? I havnt tried it, as I dont want to burn the laser out. 2 Quote Share this post Link to post Share on other sites
skillet34 1 Posted June 6, 2015 The laser should swap. Both are hop-141x or something to that effect. Can you scrape and just solder a small piece of kynar to the trace? Quote Share this post Link to post Share on other sites
gavin_darkglider 1562 Posted June 6, 2015 thanks for the laser info, I have no idea where the trace is, and unfortunatly, no razor blades. it might go to ground plane for all i can tell. I just dont want to waste the r-jtag chip i have, unless someone wants this jasper with a demon. Quote Share this post Link to post Share on other sites
felida 1653 Posted June 6, 2015 thanks for the laser info, I have no idea where the trace is, and unfortunatly, no razor blades. it might go to ground plane for all i can tell. I just dont want to waste the r-jtag chip i have, unless someone wants this jasper with a demon. here is what i have checked with multimeter m8.. this is kind of a fubard 1.. but still boots.. and c15, where my thumb is, runs all across the bottom, let me know if you need spots checked else where ;-) Quote Share this post Link to post Share on other sites
felida 1653 Posted June 6, 2015 to be ALOT more specific on the points.. yellow is slim setting/gets bridged to light-blue on slim ;-) 1 Quote Share this post Link to post Share on other sites
gavin_darkglider 1562 Posted June 6, 2015 Never Mind, I found the trace, if anyone else is curious, the pad goes to the first cap, side closest to the switch. Quote Share this post Link to post Share on other sites
gavin_darkglider 1562 Posted June 6, 2015 to be ALOT more specific on the points.. yellow is slim setting/gets bridged to light-blue on slim ;-) That is 1 fucked up coolrunner. Quote Share this post Link to post Share on other sites
felida 1653 Posted June 6, 2015 That is 1 fucked up coolrunner. still boots like a champ.. hahaha anyone else with a better one can easily test the same spots, and get the same results.. lol 1 Quote Share this post Link to post Share on other sites