coorva 10 Posted April 11, 2015 hey guys just installed CR4 everything looks good for the solder on a falcon trying to boot to Xell green light glitches 4 times then get three red rings,,any ideas on this one,,thanks 2 Quote Share this post Link to post Share on other sites
Swizzy 2084 Posted April 11, 2015 Did it work before you started? have you checked what Error code it has? 3 Red rings don't say much, but you'll likely have 0020 or so... that'd indicate a problem with the cpu_pll_bypass point another alternative is that you messed up the JTAG soldering... (it's standard JTAG + the chip) Quote Share this post Link to post Share on other sites
coorva 10 Posted April 12, 2015 yes one f the wires under the board was shorting out,,took me awhile to find it cause it glitch and when it tried to boot it red ringed,,all good and yes it was code 0020 Quote Share this post Link to post Share on other sites
Swizzy 2084 Posted April 12, 2015 yes one f the wires under the board was shorting out,,took me awhile to find it cause it glitch and when it tried to boot it red ringed,,all good and yes it was code 0020 The shorted wire was the one directly under the CPU right? 1 Quote Share this post Link to post Share on other sites
coorva 10 Posted April 13, 2015 no actually it was the wire from jtag ALT V2 QSB to the D2N1 pin,,right at the pin it was grounding out,,thats why it took so long to find Quote Share this post Link to post Share on other sites