carval444

all right! thank you very much! you helped me way better than the people at se7ensins! Keep up the good work/help support.... Thank you!

the unplug/replug didnt work. I found my old windows xp machine and used nadpro + drivers on there. The 3.0 didnt work but the 2.0e DID!!! All without errors. I will now desolder the matrix and i'll let you know if it worked ALL RIGHT!!!!! Thank you very much for helping me out! my console turns on again like before!!! Thank you!!! I have just 2 more little questions: 1 what is the best option for re modding my xbox?(like rgh2,rgh2+,..... and maybe a link?) 2 Is there a way to test my matrix glitcher v3 before re-soldering it to the xbox and doing the stuff all over again? Thank you very much!!! I am so happy right now!

with nandpro when writing it says usb_control_msg failed -5 when writing every block What does it mean?

Could not detect a flash controller! Incompatible ARM firmware for this version of NandPro! Thats what i got from my cmd. I have probably an old windows xp laptop laying around that I used for my jtag. But this is gonna take a couple of hours. Mayby an easy fix for the error I got? only when I let spi nand in usb and psu to xbox and start batch it gives me this Looking for usb interface device Incompatible ARM firmware for this version of NandPro! Flash Config: 0x00000001 Block Size: 16KB Block Limits: 0x000000..0x0003FF File: Erasing Error: 0 erasing block 0 Error: 0 erasing block 1 Error: 0 erasing block 2 and so on...... when i try to do the thing you said to do psu in/out, it wouldnt erease anymore and it gives the error like in the post above hmm weird but i am making progress. after those erasing block errors went to jrunner and wrote the stock nand back. It gaves me a failed to write by EVERY block, but when i click the ? to know my motherboard everything shows up normally??? hmm weird but i am making progress. after those erasing block errors went to jrunner and wrote the stock nand back. It gaves me a failed to write by EVERY block, but when i click the ? to know my motherboard everything shows up normally??? Checking Console.. Version: 01 Flash Config: 0x00023010 00023010 Trinity, Jasper 16MB CB Version: 9231 Trinity I have read the nand again and compaired with a backup an it looks like they are the same! Sould I remove the nand reader and try to boot the console?

Thank you, I have a matrix spi nand reader that I use for reading/writing the nand. Do you mean I have to continuously pull out an in the psu on the motherboard? And I checked the motherboard multiple times before and no solder spills thanks

Hi, I have recently RGH2'd my trinity. Everything went OK but after I made my cpu_rst wire shorter nothing would work anymore. All I got was the "PLING" sound the xbox makes to turn on. Nothing more. No green light, no red light, nothing. So I desoldered everything and tried to reflash the xbox to stock but I can't read my nand anymore. J-Runner wont read or write my NAND anymore. It gives me a 0F000000... Can't read NAND error. I read that it is possible to shrten pin 44-47 or something on the NAND or short them all at the same time. What sould I do?