slick.mcfavorite 2 Posted August 3, 2014 Hi, I'm new to the scene and have been desperately trying to figure out this problem out on my own, but I think I need some help now... I recently bought a JTAG Jasper that came pre-installed with FSD 2.2. It worked with most games I used, but for whatever reason I couldn't get Auto Disk Swap to work so I decided to bite the bullet and upgrade to FSD 3 rev 775. I followed this tutorial: http://www.realmodscene.com/index.php?/topic/413-quick-and-easy-way-to-update-your-jtagrgh/ The only change from this tutorial I made were I used Kernel 16747, which was a default option in XeBuild 2.093. Everything was going smoothly until after I wrote the hacked NAND Flash back to my Xbox. This is where my problems began. I rebooted my Xbox and it booted right into the updated Xbox Metro dash. I had planned on using the FSD3 installer, which I was sort of able to get working. At first I couldn't connect online to update to the latest version. However, I was able to install it by only checking off these boxes: "Install F3" and "Remove existing install". At this point, I could run FSD3 and actually play the games that I had my previous install. Afterwards, I rebooted my Xbox, and it did not open up FSD3 and instead launches back to the Xbox Metro Dash. I am unable to get back into FSD3 unless I reinstall it. I made sure that the launch.ini file points to the correct FSD3 XEX path - you can see it here: http://pastebin.com/36i5n6qt Other key info: - The Xbox Metro Dash shows the correct kernel running in system info: 16747 - I tried booting up holding RB, X, Y buttons to try and boot into FSD/XEX or whatever... I saw this mentioned in a few other articles. It never worked, and still booted into Metro Dash. - I also tried installing FSD3 with the "Install and configure Dashlaunch" box checked. After FSD3 installed, I was in the DashLaunch config but it hangs immediately when I tried to set the 'Default' path. Any ideas on what problem could be messing this up this install? Let me know if I'm missing any info that could help diagnose. Thank you for your help!!! 1 Quote Share this post Link to post Share on other sites
doctor855 1 Posted August 4, 2014 reinstall DL3.12 and then reinstall fsd finally set default path wish you are lucky! 1 Quote Share this post Link to post Share on other sites
slick.mcfavorite 2 Posted August 17, 2014 reinstall DL3.12 and then reinstall fsd finally set default path wish you are lucky! Just wanted to follow up that DL 3.12 fixed everything! Thanks for the help, doctor855 1 Quote Share this post Link to post Share on other sites
