BenMitnicK 33 Posted May 23, 2020 7 hours ago, Bazatree said: Thank you for updating the tool! Does anyone know how to change the output folder? I mean, the tool always keep creating new files in the old folder despite the fact that I store it in a different folder. JRunner Settings 1 Quote Share this post Link to post Share on other sites
Achm3t 0 Posted July 5, 2020 Hi there! First of all, great thanks goes to Ben cause he is not forgetting about j-runner and updates this great tool! My question is simple: is there any possibility to integrate into j-runner support of squirt programmer (it is FTDI based). AutoGG works with it and I can say that this programmer is really fast! (about 1:15 sec. on 16mb, and less than 5 min on 64mb jasper BB). It is almost twice as fast as nand-x! But personally I don’t like AutoGG at all . Quote Share this post Link to post Share on other sites
rub3n 0 Posted October 7, 2020 Hi, I'm using this version and I've an error creating XeBuild Image. I need some help, please! Thanks! Quote Share this post Link to post Share on other sites
moses_373 151 Posted October 8, 2020 Thanks for updating this, I just picked it up to do a fresh install tonight! Quote Share this post Link to post Share on other sites
morpheous 6 Posted October 8, 2020 4 minutes ago, moses_373 said: Thanks for updating this, I just picked it up to do a fresh install tonight! Do you play multiplayer games on xlink servers? or do you only play offline games? Quote Share this post Link to post Share on other sites
moses_373 151 Posted October 8, 2020 18 minutes ago, morpheous said: Do you play multiplayer games on xlink servers? or do you only play offline games? Mostly offline, I tend to spend my time on current gen for multiplayer. I'm actually performing this install for a friend of mine. Quote Share this post Link to post Share on other sites
morpheous 6 Posted October 8, 2020 10 minutes ago, moses_373 said: Mostly offline, I tend to spend my time on current gen for multiplayer. I'm actually performing this install for a friend of mine. Fair enough...^_^ Quote Share this post Link to post Share on other sites
akaTahz 0 Posted November 8, 2020 Great, thanks! Quote Share this post Link to post Share on other sites
jakke 0 Posted February 6, 2021 Does anyone have the files to reprogram a Coolrunner 3 Pro (CR3 Pro with DIPS) on a Trinity motherboard with a Demon? Is it even possible to do this or is the Coolrunner bricked because I accidentally reprogramed it? Or do I also need to resolder something to get the CR3 to work again when I upgraded the original Nand dashboard from 16xxx something to 17559? The CR3 with QSB and a Demon was installed around 2014 and the instructions back then. Quote Share this post Link to post Share on other sites