Billazores 0 Posted September 18, 2015 Header is wrong.. Invalid Image Failed to create ecc image RGH2 Selected Header is wrong.. Invalid Image Failed to create ecc image DEMON Hardware : Demon Phat Firmware : 1.0 Flash ID : 0x73AD Hynix (16MiB - Small block) Flash Size : 0x400 blocks of 0x4200 bytes Writing Nand Done! in 0:29 min:sec This is my first time doing a console i think i may have done something wrong my console will not boot up. and i just dont know my soldering is pretty good. It reads the nands well it just wond create a ecc file. I just cant figure it out... can someone please help me Quote Share this post Link to post Share on other sites
Billazores 0 Posted September 18, 2015 and at first i was on the xbox 360 nand and i created a ecc and wrote it to the console. would that be any factor? Quote Share this post Link to post Share on other sites
felida 1653 Posted September 18, 2015 and at first i was on the xbox 360 nand and i created a ecc and wrote it to the console. would that be any factor? try re-flashing your original nand back.. seems like your chip isn't wired correctly.. and just asking since you didn't mention it.. DO you have a modchip BESIDES the demon(as that is just a 2ndary nand, NOT a glitch chip) Quote Share this post Link to post Share on other sites
Billazores 0 Posted September 18, 2015 try re-flashing your original nand back.. seems like your chip isn't wired correctly.. and just asking since you didn't mention it.. DO you have a modchip BESIDES the demon(as that is just a 2ndary nand, NOT a glitch chip) i have no idea how to do that man. im sorry but i have a cr4 xl on there and i have a nandx qsb then the jrp qsb and the demon Quote Share this post Link to post Share on other sites
felida 1653 Posted September 18, 2015 i have no idea how to do that man. im sorry but i have a cr4 xl on there and i have a nandx qsb then the jrp qsb and the demon don't forget the GREEN wire this time!! Quote Share this post Link to post Share on other sites