Yazeed98 0 Posted November 29, 2012 Hi i have install the new F3 dash when i try to click test after that it say fail for broadcast and the data i have putted the broadcast : 3071 and the data : 3072 here is how i portforward [/url] Quote Share this post Link to post Share on other sites
smirnov 0 Posted November 29, 2012 Is this on your router? Check the settings from your modem too, it could be possible that you will have to open theme there aswell. Quote Share this post Link to post Share on other sites
thiago_tuto_360 1 Posted November 29, 2012 Hi i have install the new F3 dash when i try to click test after that it say fail for broadcast and the data i have putted the broadcast : 3071 and the data : 3072 here is how i portforward [/url] Dear fellow I had the same problem and did the following which worked for min. vc opened four doors with two tcp and udp two, like I did before I did just open a tcp and udp 1000 to 1001 1001 to 1001 Excuse my English because I speak Portuguese I have helped Quote Share this post Link to post Share on other sites
Yazeed98 0 Posted November 29, 2012 what do i write like the picture Quote Share this post Link to post Share on other sites
Phazon 6 Posted November 29, 2012 do you have upnp enabled? I'm pretty sure if you have to disable it if you portfowarded, and I had enable the settings on my modem while my xbox was on. if you're doing what he said then you would write tcp 1000 - 1001 udp 1000 - 1001 tcp 1001 - 1001 udp 1001 - 1001 also since it's in the beta it might be a false negative, so have you tried connecting to any matches anyways? Quote Share this post Link to post Share on other sites