JPizzle 0 Posted July 9, 2012 Xecuter DemoN Toolbox v1.01 - June 21st 2012 First connect DemoN via a MicroUSB cable (move switch to "PC"). (The ToolBox tabs will not work unless the DemoN is connected to USB and detected correctly - these are all safety measures) Then install the toolbox and make sure the "Install USB Driver" is ticked (Toolbox will not run until DemoN has been connected and installed). You can test full read/write before you install to your Xbox (so you know its working fine and you can blame your soldering if it isn't) We also recommend you install the ext module via the shielded FFC ribbon cable and test nand switching too (the DemoN Toolbox will tell you which nand is selected and the LED will work also). These tests will help you determine that everything is working perfectly BEFORE you even get your soldering iron out Changelog v1.01 Added Read/Write Times Auto Scroll CLI Window Xbox 360 Power Buttons Displayed Better Fixed Toolbar Icon Changelog v1.00 - First Release demon.toolbox.v1.01.rar Quote Share this post Link to post Share on other sites
moses_373 151 Posted March 5, 2015 thank you for posting this, xecuter's link is down in their tutorial section Quote Share this post Link to post Share on other sites
gavin_darkglider 1562 Posted March 5, 2015 thank you for posting this, xecuter's link is down in their tutorial section This is obsolete, just use j-runner, and the demon driver. Quote Share this post Link to post Share on other sites
FaTaLiiTYz 56 Posted August 16, 2016 Thanks, will grab this for archival purposes. Quote Share this post Link to post Share on other sites