Marcio Fontes 0 Posted September 10, 2013 I have a problem trying to use the new dashlaunch v3.08. I been using dashlaunch 3.07 since it came out with no problems but the new one I cannot get the udp server to start up. I press the button to start it and the option is ticked to enabled but then I go to system info tab and it says updserv is not running. Also while dashlaunch is active the whole time on 3.07 it used to say board: corona, flash: corona, etc in the bottom right hand corner but now it says everything except for the flash type. It just says board: corona, flash: unknown, and the rest is still the same. Also when I enable the ftp option is says it's running but it doesn't enable either. Other than those three things dashlaunch works perfect. Quote Share this post Link to post Share on other sites
enzoerbisti 44 Posted September 10, 2013 I have a problem trying to use the new dashlaunch v3.08. I been using dashlaunch 3.07 since it came out with no problems but the new one I cannot get the udp server to start up. I press the button to start it and the option is ticked to enabled but then I go to system info tab and it says updserv is not running. Also while dashlaunch is active the whole time on 3.07 it used to say board: corona, flash: corona, etc in the bottom right hand corner but now it says everything except for the flash type. It just says board: corona, flash: unknown, and the rest is still the same. Also when I enable the ftp option is says it's running but it doesn't enable either. Other than those three things dashlaunch works perfect. try the new dashlaunch that come today i think.....dash launch 3.09 (can get it at logic-sunrise.com) - fix in update server for corona 16M consoles (thanks Danny Lane!) - added exception logging to installer - fix some minor bugs - *known issue* some situations are causing a black screen when starting installer, it somehow seems to be related to USB devices and/or signed in profiles. If you run into this issue, try the debug version of installer - it's slower because it's logging to disk but apparently works fine. (thanks again Danny!) Quote Share this post Link to post Share on other sites
Marcio Fontes 0 Posted September 10, 2013 try the new dashlaunch that come today i think.....dash launch 3.09 (can get it at logic-sunrise.com) thank you. I will test later Quote Share this post Link to post Share on other sites