tnk 0 Posted December 15, 2015 Hello everyone, i just wanted to ask your help, my brother deleted something, lhelper i guess it is called(it was on aurora), because he didn't know what this does, and then i went to system settings on normal dash, and i was surprised, because nothing appeared, just an error, i tap ok, showed me usual dashboard but no writing on tabs, or anything, i went back to aurora, to check my files on file manager, and then i checked these directories: Flash and system, but were empty, like nothing, no bootanim.xex, nothing, so i got scared and restarted the xbox, and now won't bootup, neither the normal dash, but when i tap the "eject disk" button it boot me up to xell, so my question is: how to fix this? to boot on aurora or normal dash? I am not an expert on fixing something, but i would do anything to fix this, can someone help me to recover the flash and system files? Quote Share this post Link to post Share on other sites
Swizzy 2083 Posted December 15, 2015 You have to reflash your nand, he probably deleted everything on flash... or some vital files at the very least... You should tell your brother NOT to touch anything he doesn't know what it is... What model of console do you have? you should probably dump using XeLL and rebuild your NAND using the latest xeBuild/xeBuild GUI, if you have a dump that is not 48MB (made by XeLL) then you'll be able to recover using only XeLL and a USB thumbdrive/hdd, if it's 48MB you have to open the console and reflash the MMC with hardware Quote Share this post Link to post Share on other sites
tnk 0 Posted December 15, 2015 Ok, i have the latest slim console, slim E, using RGH v2, the motherboard is a Corona(i think 3.0), how can i find out if it's a 48Mb or not? Before he deleted those things, i saw that the size of those directories were 15 mb about, so from here i can tell that it's not 48 mb? I never (re)flashed a console before ^^ so i should be very careful with this, i watched a tutorial and at a certain moment he said to get a certain file, flashnand.bin, something like this, but i don't know from where if you could help me with this, i will be very grateful. Thank you. Quote Share this post Link to post Share on other sites
Swizzy 2083 Posted December 15, 2015 Start by launching XeLL with a network cable attached, next when it's booted up you'll see it looking for "xenon.elf" and a bunch of other things on various devices, you should also see a IP address listed, go to: http://<IP address listed>/ in your favorite browser, then download Flash and Fuses, from there, you can build a new nand using xeBuild GUI (read my signature for a guide on how to do that, skip the parts that says to run Simple 360 NAND Flasher) Once you get to the parts where it says to flash the nand, you place "updflash.bin" on a FAT32 USB device, and reboot XeLL... if all goes well, it should start flashing your console and it should be good to go... Quote Share this post Link to post Share on other sites
tnk 0 Posted December 15, 2015 Ok Swizzy, thanks for the help, i owe you a beer I will tell you tomorrow if all went well. Quote Share this post Link to post Share on other sites